Decimal Point Digit Setting
Decimal point digit setting p.147
As an example, here is an explanation of the procedure for setting the number of digits after the decimal point
to "3".
Operating procedure
Steps
Key operation
1 to 3
For moving to "BINARY", see steps 1 to 3 in p.264.
4
5
6
ZW User's Manual
Display
Description
Press the
key.
Select the number of digits after the decimal point.
The current set value is displayed on the sub-display.
Press
In this example, select "3DIG" and press the
Press and hold the
/
keys to select "DEC.NUM" and press the
/
key to enter editing mode and the sub-display blinks.
key for two seconds to enter the RUN mode.
key.
Connecting Parallel I/O
269