Omron ZW-C1*T User Manual page 269

Adjusting the analog output value
Adjusting the analog output value p.141
As an example, the following explains the procedure for correcting 4 mA output (Point1) and 20 mA output
(Point2).
Operating procedure
Steps Key operation
1 to 3 For moving to "ANALOG", see steps 1 to 3 in p.264.
4
5
6
7
8
9
10
11
ZW User's Manual
Display Description
Press the
Select analog output correction ON/OFF.
The current setting value is displayed on the sub-display.
Press
In this example, select "ON" and press the
Set the reference value of the point1.
The current set value for the point1 is displayed on the sub-display.
Press
In this example, select "4mA" and press the
Set the adjustment value of the point1.
Press the
press the
Next, check the ammeter value and press the
To re-adjust, press the
Set the reference value of the point2.
The current set value for the point2 is displayed on the sub-display.
Press
In this example, select "20mA" and press the
Set the adjustment value of the point2.
Press the
press the
Next, check the ammeter value and press the
To re-adjust, press the
"OK/CAN" is displayed on the sub-display.
Press the
Press and hold the
/ keys to select "CALIB" and press the
/ key to enter editing mode and the sub-display blinks.
/ key to enter editing mode and the sub-display blinks.
/ / / keys to input the adjustment value and
key.
key.
/ key to enter editing mode and the sub-display blinks.
/ / / keys to input the adjustment value and
key.
key.
key to execute correction or
key for two seconds to enter the RUN mode.
key.
key.
key.
key.
key.
key.
key to cancel.
Connecting Parallel I/O
267