Sensor Controller - Omron ZW-C1*T User Manual

Sensor controller

Specifications
Item
Input/Output type
Number of connected Sensor Heads
Sensor Head compatibility
Light source for measurement
Segment Main display
display
Sub-display
LED display Status indicators
External inter- Ethernet
face
RS-232C
20-pole ter-
minal block
52-pole
extension
connector
294
Specifications and External Dimensions
Specifications
ZW-C10T
NPN
1 per Sensor Controller
Available
White LED
11-segment red display, 6 digits
11-segment green display, 6 digits
HIGH (orange), PASS (green), LOW (orange), STABILITY (green), ZERO
(green), ENABLE (green), THRESHOLD-H (orange), THRESHOLD-L
(orange), RUN (green)
1 port, 100BASE-TX/10BASE-T
1 port, 115,200 bps max.
Judgment output Transistor output system
(HIGH 1/PASS 1/LOW 1) Output voltage: 21.6 to 30 VDC
Load current: 50 mA or less
BUSY output (BUSY 1)
Residual voltage when turning ON: 1.2 V or less
Leakage voltage when turning OFF: 0.1 mA or less
ALARM output (ALARM)
ENABLE output
(ENABLE 1)
-10 to +10 V, Output impedance: 100 
Analog voltage output
(OUT1V)
4 to 20 mA, Max. load resistance: 300 
Analog current output
(OUT1A)
LED OFF input DC input system
(LED OFF 1) Input voltage: 24 VDC ± 10% (21.6 to 26.4 VDC)
Input current: 7 mA Type. (24 VDC)
ZERO RESET input
ON voltage/ON current: 19 V/3 mA or less
(ZERO 1)
ON voltage/ON current: 5 V/1 mA or less
TIMING input (TIMING
1)
RESET input (RESET 1)
Binary Measured Transistor output system
value output Output voltage: 21.6 to 30 VDC
(BINARY 0 to Load current: 50 mA or less
20) Residual voltage when turning ON: 1.2 V or less
Leakage voltage when turning OFF: 0.1 mA or less
Gate signal
output (GATE)
Selected task
output
(BINARY_OU
T1/2)
Selected task DC input system
input Input voltage: 24 VDC ±10 % (21.6 to 26.4 VDC)
(BINARY_SE Input current: 7 mA Typ. (24 VDC)
L1/2) Voltage/Current when turning ON: 19 V/3 mA or more
Voltage/Current when turning OFF: 5 V/1 mA or less
ZW-C10AT ZW-C15T
PNP
ZW-C15AT
ZW User's Manual