System Configuration - Omron ZW-C1*T User Manual

2-1 System Configuration

System Configuration

Photoelectric and
adjacent sensors
The system receives
trigger signals to
control measuring
timings.
20
System Configuration
ZW series
Basic configuration
Sensor head
ZW-S07
ZW-S20
ZW-S30
ZW-S40
ZW-SR07
ZW-SR20
ZW-SR40
Detects a target to
measure.
Calibration ROM
(included with sensor head)
Sensor Controller
ZW-C10T/C10AT
ZW-C15T/C15AT
Ethernet (note1)
Sysmac Studio
Measurement
Sensor Edition
(Exclusive personal
computer software)
Personal
computer
Sysmac-ME2@@L
Allows making advanced settings and
checking up measured values easily using
exclusive personal computer software.
It is also possible to use SmartMonitorZW
instead of Sysmac Studio.
Accessory for the Sensor Controller
ZW-C10AT/C15AT.
(Note1) Ethernet cable (sold separately)
Prepare commercially available Ethernet cable
satisfying the following requirements:
- Category 5e or more, 30 m or less
- RJ45 connector (8-pin modular jack)
- For direct connection: Select cross cable.
- For connection through an industrial switching hub (note 4):
Select straight cable.
Extension fiber cable (optional)
A exclusive extension fiber cable is available to
place the Sensor Head and Sensor Controller far apart
than the normal distance to each other.
Use the exclusive product for correct measurements.
Connecting adapter
Extension fiber cable
(included with the fiber
ZW-XF_ _R
cable for extension)
(2 m/5 m/10 m/20 m/30 m)
ZW-XFC
Measurement data can be easily loaded
into a PLC or personal computer through
Ethernet connections.
The Sensor Controller can be remotely controlled
from a personal computer; including switching
between or changing setting data and entering
measuring triggers.
(Communication with multiple devices
simultaneously cannot be achieved via Ethernet.)
Ethernet (note1) (note4)
Various Controller operations,
including, taking measured values
and judgment results, switching
between or changing setting data
or entering measuring triggers, are
available.
RS-232C cable
(note2)
Displaying analog signals in
waveform from measured values
or judgment results in color is
available.
Analog output
Outputting measured values
or judgment results at a high
speed in parallel is available.
Parallel output (note3)
(Note2) RS-232C cable (optional)
Depending on connecting devices, exclusive cables
may be supplied.
For PLC/programmable terminal: ZW-XPT2
For personal computer: ZW-XRS2
(Note3) Parallel cable (optional)
A parallel cable for 52-pole extension connector
(ZW-XCP2) with 2 m cable is available.
(Note 4) Industrial network hub (sold separately)
Use the recommended products below:
W4S1-0 _ (Omron)
3-port type
PLC
PC
PLC
PC
Data loggers, etc.
PC
High-speed
input board
5-port type
ZW User's Manual