Handlebars - Rocket Iii And Classic; Removal - Triumph Rocket III Classic Service Manual

Handlebars - Rocket III and Classic
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
Removal
1.
Undo the fixing screws and remove the end weights
from the handlebars.
1. Handlebar
2. End weight assembly
Note:
• Each end weight assembly consists of the end
weight, two damper bushes, a stepped sleeve,
a finisher and a fixing screw.
1.
Fixing screw
2. Finisher
3. End weight
4. Damper bushes
5. Stepped sleeve
Frame and Bodywork
2. Release the wiring and brake hose from its clips on
either side of the handlebar.
3. Undo the screws and free the left switchgear
assembly from the handlebar.
4. Unscrew the bolts and remove the clamp from the
clutch lever assembly.
5. Undo the screws and free the right switchgear
assembly from the front brake master cylinder. Free
the switch wiring from the handlebars.
6. Unscrew the bolts and remove the clamp from the
master cylinder.
Note:
• For Rocket III and Classic models up to VI N
241569 continue from step 7 to step 10.
• For Rocket III and Classic models from VIN
241570 continue from step 11 to step 14.
Rocket III and Classic models up to VIN 241569
Z Release the two screws securing the upper cover of
the handlebar clamp to the lower section.
1. Upper cover
2. Screws
SelVice Manual - Rocket
1111
Classic
1
Touring
17.31