Triumph Rocket III Classic Service Manual page 155

9. Slide the gear change shaft out of the crankcase,
collecting the gear change actuator arm and detent
spring at the same time.
1.
Gear change shaft
2. Gear change actuator arm
3. Detent arm
10. Insert a soft-faced tool through the selector drum to
prevent it from turning, and then undo the screw
securing the detent wheel to the selector drum.
1. Selector drum
2. Detent wheel
Transmission
11. Release the small screw securing the selector drum,
bearing and keeper plate to the crankcase.
1.
Selector drum bearing
2. Screw
3. Keeper plate
12. Pull/push the selector drum out and in to dislodge
the bearing, then remove the drum from the
crankcase.
13. To remove the actuator shaft, slide it inwards and
recover it from inside the crankcase.
1. Actuator shaft
Note:
• It is not normally necessary to remove the
inner selector drum bearing, though it is
possible to do so by drifting from behind its
recess in the crankcase.
14. If necessary, remove the spring abutment bolt.
SelVice Manual - Rocket Ill/ Classic / Touring
8.9