4.
Position the swinging arm to the drive shaft and
manoeuvre the arm along the drive shaft.
Fitting the swinging arm
5.
Engage the threads of the swinging arm pivots to the
frame.
1.
Pivots
2. Frame
6.
Position the swinging arm bearings to the pivots.
Z
Engage the pivots to the swinging arm bearings.
8.
Tighten the left hand pivot to 100 Nm.
9.
Tighten the right hand pivot to
15 Nm.
10. Tighten the right hand locking ring to 100 Nm
using tool T3880062.
Rear Suspension
1.
Tool T3880062
11.
Apply a smear of general purpose grease to the
drive shaft sleeve, inside and out.
12. Refit the drive shaft gaiter to the swinging arm and
crankcase. Ensure it is engaged throughout its entire
circumference both ends.
13. Refit the drive shaft sleeve.
i5 \ '
1. Drive shaft
2.
Swinging arm
3. Sleeve
SelVice Manual - Rocket Ill/ Classic / Touring
13.9