Triumph Rocket III Classic Service Manual page 199

Note:
• Rocket III shown, Rocket III Classic and Touring
are similar.
18. Temporarily support the rear brake master cylinder
then remove the bolts securing it to the footrest
mounting bar.
1.
Footrest mounting bar
2.
Master cylinder bolts
Note:
• It is not necessary to disconnect the brake pipe
from the master cylinder.
19. For Rocket III and Classic only: Unclip the brake
pipe.
I
P-~:;;;;;;;:;;;;;;;~ ~==~\ \~j ;;;;:;;;;;;:;;~~~
1. Brake pipe
2.
Clips
20. Remove the heat shield from the brake pipe joint.
Engine Removal and Refit
21. Release the fixing securing the brake pipe joint to
the frame outrigger.
ebb<
1. Brake pipe joint
2. Bolt
----~
~1~
22. Detach the five bolts securing the footrest mounting
bar to the frame and crankcase. Detach the bar.
.·,clj··caulion
When repositioning the rear brake master cylinder, take
care to prevent the steel brake pipe from becoming
distorted.
23. Position the master cylinder, brake pipe and joint in a
safe place, preventing the brake fluid reservoir from
becoming inverted.
24. For Rocket III only: Select neutral and note the
position of the gear change crank relative to the
selector shaft.
1.
Gear change crank
2. Selector shaft
SelVice Manual - Rocket
1111
Classic
I
Touring
10.3