Triumph Rocket III Classic Service Manual page 401

Idle Speed Control Stepper Motor
Removal
Fuel System/Engine Management
Z Remove the two screws securing the idle speed
control stepper motor to its bracket, then remove the
stepper motor.
1. Remove the seat (see page
17-17
for Rocket
III
and
3
Classic, see page
17-18
for Rocket
III
Touring).
2. Disconnect the battery, negative (black) lead first.
3. Remove the throttle bodies (see page 11-188>.
4. Remove the nut, metal washer and plastic washer
attaching the idle control stepper arm to the idle
speed control lever.
f. Idle control stepper arm
2. Idle speed control lever
3. Nut etc.
5. Using the linkage, rather than the butterfly plates,
fully open the primary throttle by hand.
6.
Turn the idle speed control lever away from the
stepper arm and remove the plastic collar and spring.
1. Collar
2. Spring
=-
1. Idte speed control stepper motor
2.
Bracket
3. Fixing"
Installation
1.
Turn the idle speed control lever until the stepper
motor can be fitted without obstruction of any kind.
2.
Locate the stepper motor to its bracket and tighten
the fixings to 3.5 Nm.
3.
Locate the spring and plastic collar.
1. Collar
2. Spring
4.
Fit the plastic washer through the lever then fit the
metal washer and nut.
5.
Refit the throttle bodies (see page 11-190>, but do
not fit the intake cover.
6.
Temporarily reconnect the battery, positive (red) lead
first.
Z Turn the ignition to the ON position.
S. Connect the service diagnostic tool and scroll
through to, and select the 'ADJUST TUNE' option.
SelVice Manual - Rocket Ill/ Classic / Touring
11.197