Triumph Rocket III Classic Service Manual page 396

Fuel System/Engine Management
15. Refit the intake plenum to the throttle bodies and
intake duct. Tighten all hose clips.
1. Intake plenum
2. Intake duct
3. Clips
16. Reconnect the MAP sensor hoses.
~, V-=~
1. Map sensor hose to centre throHle body
2. Map sensor hose to sensor
lZ Reconnect the MAP and air temperature sensor
connections.
Ensure the plenum is positively located to the throttle
bodies and intake duct and is retained by the clips
through their full circumference. Rectify if necessary as
poor engine performance and damage may result from
poor plenum/duct sealing.
18. Refit the fuel tank (see page 11-150 for Rocket III
and Classic, see page
11-154
for Rocket III Touring).
19. Refit the intake cover (see page
1/-149
for Rocket III
and Classic, see page
11-152
for Rocket III Touring).
20. Reconnect the battery, positive (red) lead first.
21. Refit the seat (see page 17- 17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
Injectors and Fuel Rail
Removal
1. Remove the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
2. Disconnect the battery, negative (blackllead first.
3. Remove the throttle bodies (see page 11- 188).
4. Remove the three screws securing the fuel rail and
fuel hose to the throttle body assembly.
1
"' "
1. Fuel rail
2. Screws
Note:
• The fuel rail and injectors are removed from
the throttle bodies together.
5. Gently ease the fuel rail and injectors upwards to
release them from the throttles.
1. Fuel rail
2. Injectors
11.192
SelVice Manual - Rocket 1111 Classic 1 Touring
(
(