Triumph Rocket III Classic Service Manual page 412

Fuel System/Engine Management
13. Reconnect the oxygen sensor to the main wiring
harness.
14. Fit the isolator rubbers to the tags at the bottom of
the upper heat shields.
15. Position each of the upper heat shields to the
headers, engaging the isolators in the corresponding
brackets in the inner heat shield.
'""
1. Inner heat shield
2. Bracket
3. Isolator
4. Upper heat shields
16. Fit the upper heat shield screws and flat washers,
then tighten the screws to 7 Nm.
lZ Position the lower heat shields to the header pipes.
18. Fit the lower heat shield screws and Hat washers,
then tighten the screws to 7 Nm.
19. Fit new gaskets to each silencer.
20. Position the silencer clamps on to each silencer.
21. Fit the heat shield to the left hand silencer. lighten
the front fixing to 7 Nm and the clamp fixing to
10Nm.
2
~oo
1. Heat shield front fixing
2. Clamp
22. Fit each silencer to the exhaust link box and position
the silencer mountings to the pannier rail.
23. Engage the silencer mounting fixings, finger tight.
24. lighten each silencer rnounting fixing to 22 Nm.
25. lighten each silencer clamp to 22 Nm.
26. Position the heat shield to the right hand silencer.
2Z Fit the silencer heat shield screw and Hat washer,
then tighten the screw to 7 Nm. Fit the clamp and
tighten the fixing to 10 Nm.
-_-.A...,.---~-3 ~
1. Heat shield front fixing
1. Clamp
28. Reconnect the battery, positive (red) lead first.
29. Refit the seat (see page 17-18).
30. Refit the panniers (see page 17-22).
11.208
Service Manual - Rocket
1111
Classic
I
Touring
(
(