Triumph Rocket III Classic Service Manual page 399

(
(
checking that cables and harnesses do not bind. A cable
or harness that binds will restrict the steering and may
cause loss of control and an accident.
15. Support the tank, remove and stow the tank prop,
then lower the tank to the frame and secure it (see
page 11-149 for Rocket III and Classic, see page
11-
152
for Rocket III Touring).
16. Refit the intake cover (see page 11-149 for Rocket III
and Classic, see page
11-152
for Rocket
III
Touring).
lZ Reconnect the battery, positive (red) lead first.
18. Refit the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
Fuel System/Engine Management
Secondary Throttle Potentiometer
Note:
• The primary and secondary throttle position
sensors are different and must never be
transposed, For ease of identification, the
primary throttle position sensor has a shorter
connector cable than the secondary.
Removal
1.
Remove the seat (see page 17-17 for Rocket
III
and
Classic, see page 17-18 for Rocket III Touring).
2. Disconnect the battery, negative (black) lead first.
3. Remove the throttle bodies (see page
11-188l.
4. Remove the Torx screw securing the secondary
throttle position sensor to the throttle body.
""
Secondary throttle position sensor
5. Turn the sensor clockwise and detach it from the
throttle body by gently pulling outwards.
Installation
1. Lubricate the sensor O-ring with a smear of
petroleum jelly.
2. Manually push the second throttle to the fully open
position.
SelVice Manual - Rocket Ill/ Classic / Touring
11.195