Table of Contents
Advertisement
11.
From inside the rear of the crankcases, fit the bearing
cap securing the output shaft to the lower crankcase.
1. Output shaft bearing cap
12.
Fit the screws into the lower crankcase and hand
tighten them.
13.
Position the main bearing ladder and baffle to the
crankcase (baffle lugs facing into the engine).
cbxp
1. Main bearing ladder
2. Baffle
3. Baffle lugs
Note:
•
For models with engine number up to 214416
continue from step 14 to 15. Then continue
from step 17 to step 26.
•
For models with engine number up to 214417
continue from step 16 to step 26.
Models up to engine number 214416
14. Tighten the crankcase screws as follows:
Note:
•
The crankcase screws are tightened in stages.
Crankshaft
,A.Caution
Failure to follow the correct screw tightening sequence
may result in permanent crankcase damage.
Stage 1 - all screws
In the sequence shown below, tighten all crankcase fixings
to 10 Nm.
17
6
2--H--~
22-,&,==
25~>==>rf
20
27
14
19
7
8 4 10
21
15
11
32
13
30
29
12
31
16
33
Crankcase Fixing Tightening Sequence, all
fixings
Stage
2
In the sequence shown below, tighten fixings 1 through 8
to
20
Nm.
Stage 3
In the sequence shown below, tighten bolts 1 through 8
through a further 90
0
using tool 3880105-T0301 or
similar to measure the torque-angle.
Crankcase Bolt Tightening Sequence, fixings
1-8
Service Manual - Rocket Ill/ Classic / Touring
5.9
Advertisement
Chapters
Table of Contents
