Triumph Rocket III Classic Service Manual page 520

Brakes
5. Align the brake pedal with the pushrod, engage the
clevis and retain it with the clip. Ensure the clip is
fitted as shown below.
1.
Pedal
2. Pushrod
3. Clevis pin
Use only D.O:r. 4 specification brake fluid as listed in
the general information section of this manual. The use
of brake fluids other than those D.O.T. 4 fluids listed in
the general information section may reduce the
efficiency of the braking system leading to loss of
motorcycle control and an accident. Observe the brake
fluid handling warnings given earlier in this section of
the manual.
6. Refit the heel guard tightening the fixings to 9 Nm.
1.
Heel guard
2. Fixings
Z Fill and bleed the rear brake system (see page
15-
27>.
8. Reconnect the battery, positive (red) lead first.
9. Refit the seat (see page 17-17) for Rocket III and
Classic, see page 17-18 for Rocket III Touring}.
10. Check the operation of the rear brake. Rectify as
necessary.
It is dangerous to operate the motorcycle with defective
brakes and you must have your authorised Triumph
dealer take remedial action before you attempt to ride
the motorcycle again. Failure to take remedial action
may reduce braking efficiency leading to loss of
motorcycle control and an accident.
15.36
SelVice Manual - Rocket 1111 Classic 1 Touring