Triumph Rocket III Classic Service Manual page 157

10. Feed the gear change shaft through the crankcase,
engaging it in the actuator arm and also attaching
the free end of the detent arm spring over the spring
abutment bolt. Ensure that the gear change return
spring also engages over the spring abutment bolt.
1. Detent arm spring
2. Spring abutment bolt
3. Gear change retum spring
11. Fit a new bolt to the gear change
tighten it to 28 Nm.
Note:
actuator and
• If a new bolt cannot be sourced, clean the
threads of the old bolt and apply a spot of
ThreeBond 1305 to the threads before fitting
it.
12. Refit the input shaft (see page 8-18>.
Note:
• Selector forks are marked A, Band C. The
marking letters always face the clutch end of
the input shaft.
Transmission
13. Place the transmission in neutral. The transmission is
in neutral when the wheel of the detent arm rests in
a tooth on the detent wheel that has a V-shaped cut-
out.
1. V-shaped cut out
2. Detent arm
14. Partially insert the selector shaft into the crankcase.
15. Position and support the selector forks in the selector
drum as noted or marked prior to removal.
ccay
1. Selector forks
2. Selector drum
3. Selector shaft
16. Feed the selector shaft through the selector forks and
secure it with a new
'e'
clip.
lZ
Assemble the crankcases (see page 5-8>,
18, Refit the engine (see page 10-5>,
SelVice Manual - Rocket III
I
Classic
I
Touring
8.11