Triumph Rocket III Classic Service Manual page 389

( 4. Remove the intake plenum chamber (see page
11-
188)
and make adjustments until the word
'BALANCED' appears in the top right hand corner of
the screen. Adjusters are located on each throttle as
shown in the diagram below.
row
1. Adjuster 1
2. Adjuster 2
5. When balanced, stop the engine, disconnect the
diagnostic tool and refit the intake plenum chamber
(see page 11-191l.
6. Refit the intake cover (see page 11-149 for Rocket III
and Classic, see page 11-152 for Rocket III Touring).
Fuel System/Engine Management
Throttle Body Balancing - Rocket '"
Touring
Note:
• The Rocket III Touring throttles cannot be
balanced using the Triumph diagnostic tool.
Instead, Triumph recommend the use of the
Souriau Indiana digital inlet vacuum analyser or
similar device.
1.
Raise and support the fuel tank (see page
11-151l.
2. Reconnect the electrical connector to the instrument
assembly and secure the instrument assembly to the
fuel tank.
1.
Protective cover
2. Electrical connector
3. Disconnect the manifold absolute pressure (MAP)
sensor electrical connector.
1.
MAP sensor
2. Electrical connector
Service Manual - Rocket 1111 Classic 1 Touring
11.185