Triumph Rocket III Classic Service Manual page 403

"'"
For example, if the voltage measured was 0.6 volts,
then the correct setting would be
0.715 - 0.725
volts.
1. AdJustment nut
19. Press the validation key marked
'*'
to fully close the
idle speed control stepper motor. After a minimum
of
15
seconds (the tool will not allow further actions
to take place during this period), press the validation
key again to return the ECM to normal control.
20.
Turn the ignition to the OFF position.
21. Disconnect the battery, negative (black) lead first.
22. Check and adjust the throttle cable settings (see
page 11-183).
throttle position sensor, or a throttle position sensor that
causes the throttle to stick could result in loss of throttle
control. Loss of throttle control could result in loss of
control of the motorcycle and an accident.
Operation of the motorcycle with an incorrectly
adjusted, incorrectly routed or damaged throttle cable
could interfere with the operation of the brakes, clutch
or the throttle itself. Any of these conditions could result
in loss of control of the motorcycle and an accident.
Move the handlebars to left and right full lock while
checking that cables and harnesses do not bind. A
cable or harness which binds will restrict the steering
and may cause loss of control and an accident.
Fuel System/Engine Management
23. Support the tank, remove and stow the tank prop,
then lower the tank to the frame and secure it (see
page 11-149 for Rocket III and Classic, see page 11-
152 for Rocket
11
I Touring).
24. Refit the intake cover (see page 11-149 for Rocket III
and Classic, see page 11-152 for Rocket III Touring).
25.
Reconnect the battery, positive (red) lead first.
26. Refit the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
SelVice Manual - Rocket Ill/ Classic / Touring
11.199