Triumph Rocket III Classic Service Manual page 479

Note:
• Make a note of the cable routings behind the
cable guide.
Z Release the two screws and remove the cable guide.
9. Slacken and remove the top nut and washer. Lift and
remove the top yoke.
1
d
1. Top nut
10. Slacken the locknut and adjuster nut.
1. Tools 3SS0140-T0301
2. Locknut
Front Suspension
11. Adjust the bearing free play as follows:
a) Tighten the adjuster nut to
40 Nm.
b) Slacken the adjuster nut fully.
d Re-tighten the adjuster nut to 6
Nm.
d) Loosen the adjuster nut by 90°. Note that there
will now be free-play present.
12. With the bearing free play correctly set, hold the
adjuster nut stationary then tighten the locknut to
40 Nm
using tools 3880140-T0301.
Note:
• Ensure the adjuster nut does not move as
the locknut is tightened.
1
1. Tools 3S .... ·' .....
·_"Tn· .. n.
13. Align the two locating holes in the forks infill shroud
to the two locating posts on the top yoke.
celk
\
1. Mounting post on top yoke
2. Forks infill shroud locating hole
3. Forks infill shroud
14. Seat the top yoke in to position.
SelVice Manual - Rocket Ill/ Classic / Touring
14.37