Triumph Rocket III Classic Service Manual page 251

9 UNLOCKECM
UN L 0 [ If E [ U
I N
f) R L I 0
UN L 0 [If
[ 0 0 E
When this key is displayed, an invalid unlock code has
been entered.
Press the Validation key
'*'
to return to the previous
screen. Enter the correct lock code to unlock the ECM.
If an incorrect unlock code is entered three times, the
screen will display 'INVALID UNLOCK CODE ECU
TAMPER DETECTED RE-DOWN LOAD TUNE' No
further attempts to enter the unlock code will be allowed.
The correct tune must then be re-downloaded in order to
allow further attempts to unlock the ECM.
Fuel System/Engine Management
10 MAIN MENU
17 R I N I7E NU
0 I R G N 0 5 T I
[
5
[
H E
[
If / R 0 J U 5 T
~
a
U I T
@!
I~
. I
<§OZ>~
gat!
1
When this screen is displayed, you have to decide
whether to proceed along one of two routes:
'DIAGNOSTICS'
'CHECK!ADJUST'
The 'DIAGNOSTICS' menu provides access to:
Current data e.g. actual engine temperature, engine
speed etc.
Diagnostic Trouble Codes (DTCs) i.e. access to codes
stored in the motor cycle ECM which indicate a confirmed
fault(s) in the system.
Function tests e.g. of tachometer, water temperature
gauge, fuel pump etc.
The 'CHECK!ADJUST' menu provides:
Checks i.e. build information, system data.
Adjustments e.g. adjustment of idle fuel/CO etc., and
entry of software updates.
Use the 'Up and Down' keys to position the cursor
opposite the desired choice, and press the Validation key
'*'.
Either 'DIAGNOSTICS' (operation III or 'CHECK!
ADJUST' (operation
29)
will be displayed, dependent on
the selection.
Note:
• If 'QUIT' is selected and the validation
key
'*'
pressed, the display will return to 'TRIUMPH
MOTORCYCLES'.
Service Manual - Rocket 1111 Classic I Touring
11.47