Triumph Rocket III Classic Service Manual page 354

Fuel System/Engine Management
3. Disconnect the fuel hose from the fuel pump plate in
the base of the tank and discard the sealing washers.
Drain the pipe contents into a suitable fuel container.
"' "
1. Fuel hose
2. Electrical connection
4. Disconnect the electrical connection from the fuel
pump plate.
5. Support the fuel tank while removing the rear
mounting bolt.
""qft
1. Rear mounting bolt
6. Raise the tank from the frame and have a colleague
collect the tank prop.
Note:
• Store the tank prop In a convenient place,
ready for when the tank is refitted.
Z Place the fuel tank in a safe place.
Fuel tank - installation
1. Position the fuel tank to the frame and install the rear
mounting bolt.
2. Pivot the front of the tank upwards at the front and
refit the tank prop to the frame and tank.
3. Tighten the rear fuel tank mounting bolt to 9 Nm.
4. Incorporating new washers, refit the fuel hose and
tighten the union to 1S Nm.
5. Reconnect the electrical supply to the fuel pump
plate.
6. Connect the breather hoses as noted/marked prior
to removal.
Z Lower and secure the fuel tank (see page 11-149).
11.150
Service Manual - Rocket 1111 Classic I Touring
(