Triumph Rocket III Classic Service Manual page 200

Engine Removal and Refit
25. For Rocket III Classic and Touring only: Select
neutral and note the position of the gear change
crank relative to the selector shaft.
"---=,
=====-
cemz1
1.
Gear change crank
2. Selector shaft
26. Remove the bolt from the gear change crank.
Detach the crank.
2Z Release the bolts securing the left hand footrest
mounting bar to the frame and engine. Detach the
bar.
28. Noting their respective positions, disconnect the
spark plug leads from the spark plugs.
29. Disconnect the side stand switch.
30. Remove the side stand complete with its mounting
bracket.
1.
Side stand switch connections
2.
Side stand bracket
31. Release the clip securing the engine breather hose to
the engine. Detach the hose.
32. Disconnect all electrical connections to the engine.
These include:
Low oil pressure warning light switch
Crankshaft position sensor
Gear position sensor
Road speed sensor
Coolant temperature sensor
Battery earth
Starter motor connections
33. Undo the bolts securing the airbox to the frame.
34. Detach the breather hose at the crankcase.
cbsl
1.
Breather hose
2. Clip
Note:
• It is not necessary
to
remove the airbox, but
allowing it to float within the frame is helpful.
35. Check that the engine is still securely supported.
36. Undo all engine mounting bolts and nuts, leaving
the bolts in place until later.
3Z Release the engine mounting adjuster locking collar
and adjusters on the right side of the frame using
service tool T3880063.
ccgb1
1.
Locking collars
2. Engine mounting adjusters
38. Have several colleagues support the frame, then
remove all engine mounting bolts from the engine
mountings.
39. Leaving the engine on its support, lift the frame off
the engine.
10.4
Service Manual - Rocket III I Classic I Touring