Triumph Rocket III Classic Service Manual page 368

Fuel System/Engine Management
6. Release the bolts securing the fuel level sensor to the
fuel tank.
1.
Bolts
Z Carefully manoeuvre the fuel level sensor out of the
fuel tank Discard the seal.
Installation
1. Position a new seal on to the fuel level sensor.
2. Refit the fuel sender to the fuel tank Fit and tighten
the bolts to 5 Nm.
3. Refit the fuel tank (see page 1/-154).
Airbox, Intake Duct and Hoses
Removal
1.
Remove the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
2.
Disconnect and remove the battery (see page 18-13).
3. Remove the fuel tank see page 1/-149 for Rocket III
and Classic, see page 1/-153 for Rocket III Touring).
4. Remove both side covers (see page 17-19).
5.
Remove the engine infill panels {see page 17-20>.
6.
Remove the rear wheel (see page 16-13) for Rocket
III and Classic, refer to 16-15>.
Z
Remove the rear mudguard (see page 17-24 for
Rocket III and Classic, see page 17-27 for Rocket III
Touring).
8.
From the left hand side, detach the roll over valve
from its clip. then release the two screws that secure
the relay pack to the airbox side.
1. Relay pack
2. Alrbox
3. Screws
4. Roil-over valve
9. Ease the relay pack from the airbox.
Note:
• It is not necessary to disconnect or remove the
relays or disconnect the roll-over valve hoses.
10. If an evaporative canister is fitted, cui the cable ties
securing it to the airbox.
11.164
Service Manual - Rocket 1111 Classic 1 Touring
(