Triumph Rocket III Classic Service Manual page 358

Fuel System/Engine Management
Fuel tank - installation
1. Position the fuel tank to the frame and install the rear
mounting bolt.
2. Pivot the front of the tank upwards at the front and
refit the tank prop to the frame and tank.
3. Tighten the rear fuel tank mounting bolt to
9 Nm.
4. Incorporating new washers, refit the fuel hose and
tighten the union to 15
Nm.
5. Attach and connect the breather pipe and harnesses
to the fuel tank as noted/marked prior to removal.
6. Lower and secure the fuel tank (see page
11-152).
Fuel Pressure Checking
Fuel pressure is checked using service tool T388004Z
-
J
Tool T3880047
1.
Raise and prop the tank (see page
11-147
for Rocket
III and Classic, see page
11-151
for Rocket III
Touring).
Note:
• After removal, the sealing washers will be used
to seal the fuel pressure gauge union to the
fuel pump plate and fuel pipe. After the fuel
pressure check as been carried out, the sealing
washers should be discarded.
(
2. Disconnect the fuel hose from the fuel pump plate in
the base of the tank and remove the sealing washers
from the banjo bolt. Do not discard the washers at (
wp
this stage. Drain the hose contents into a suitable fuel
container.
f. Fuel hose
(
11.154
Service Manual - Rocket III / Classic / Touring