Triumph Rocket III Classic Service Manual page 391

10. To adjust the throttle bodies balance, detach the
intake duct and position to one side.
1. Intake duct to plenum clips
2. Intake hose clip
3. Fixing
11. Start the engine.
Note:
• The rear adjuster will adjust cylinder 3 to
cylinder 2.
The front adjuster will adjust cylinders 2 and 3
to cylinder 1.
12. Set the adjusters such that all three cylinders have
equal vacuum readings.
1.
Rear adjuster
2. Front adjuster
13. Stop the engine.
Ensure the intake duct is positively located to the
plenum and intake hose and is retained by the clips
through their full circumference. Rectify if necessary as
poor engine performance and engine damage may
result from poor intake duct/plenum sealing.
Fuel System/Engine Management
14. Refit the intake duct and tighten the fixing to 9 Nm.
TIghten the intake hose dip and the two clips
securing the intake plenum to the intake duct.
1. Intake plenum clips
2. Intake hose clips
3. Fixing
15. Detach the analyser hoses and short tube adapters
from the map sensor hoses.
16. Reconnect the MAP sensor hoses to the T-piece.
~"' ~
1. Map sensor hose to cylinder number one
2. Map sensor hose to cylinder number two
3. Map sensor hose to cylinder number three
17. Reconnect the MAP sensor electrical connector.
Setvice Manual - Rocket Ill/ Classic I Touring
11.187