Triumph Rocket III Classic Service Manual page 382

Fuel System/Engine Management
Installation
1. Fit a new O-ring to the sensor. Lubricate the O-ring
with a smear of petroleum jelly.
2. Position the sensor to the engine and route the
wiring as noted prior to removal.
3. Retain the sensor with the screw then tighten the
screw to 9 Nm.
4. Connect the sensor to the main wiring harness. Re-
attach the connector to the bracket.
5. Position the left hand engine infill panel to the frame.
Align the screw holes in the panel with those in the
connector bracket and frame. Fit the screws and
tighten to 3 Nm.
6. Reconnect the battery, positive (red) lead first.
Z Refit the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket
III
Touring).
Crankshaft Position Sensor
Removal
1. Remove the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring).
2. Disconnect the battery, negative (blackllead first.
3. Remove the engine infill panel from the left hand
side of the engine (see page
17-20>.
Note:
• Behind the engine infill panel, secured by the
same fixings as the panel, is a connector
support bracket. The crankshaft position sensor
plug is located here.
4. Release the screw securing the sensor to the bottom
of the alternator cover.
<""
1. Crankshaft position sensor
5. Ease the sensor downwards to detach it from the
engine. Recover and discard the O-ring.
Note:
• Make a note of the sensor's wiring run in order
to return it to the same routing on assembly.
6. Trace the connector wiring back to the connector.
Disconnect the sensor and detach it from the
motorcycle.
11.178
SelVice Manual - Rocket 1111 Classic 1 Touring