Triumph Rocket III Classic Service Manual page 249

(
(
5 SWITCH ON BIKE IGNITION
5 /J I T [ H
ON 8 I K E
I G N I T I
a
N
~
I~(
Switch on the ignition. Do NOT start the engine.
Press the validation key
'*'.
During a short delay period
the tool will carry out certain validation checks.
If it detects a problem which will invalidate the test, 'DATA
LINK FAULT RETRY?' will be displayed.
If all is OK, the tool will now automatically check for a
locked ECM. Either 'UNLOCK ECM' (operation 7l will be
displayed, if the ECM is locked, or the 'MAIN MENU'
(operation 10) will appear on the screen.
Fuel System/Engine Management
6 DATA LINK FAULT RETRY?
DR T R L I N K F R U L T
I- l -
F! E T F! Y ?
@I ID
.
I~(
gaJU
1
If the above is displayed, check that the ignition is
switched on.
If the ignition is already on, the problem may be caused
by bad connections, faulty ignition switch, cable break,
faulty ECM, flat battery etc.
Press the Help key'?' for advice.
Rectify the problem and press the Validation key
'*'
to
return to 'SWITCH ON BIKE IGNITION'.
Press the Validation key
'*'
again. If the tool accepts that
the problem has been rectified, the tool will now
automatically check for a locked ECM. Either 'UNLOCK
ECM' (operation 7l will be displayed, if the ECM is locked,
or the 'MAIN MENU' (operation
10)
will appear on the
screen.
Service Manual - Rocket
1111
Classic
1
Touring
11.45