Table of Contents
Advertisement
Rapidlab 1200 Operator's Guide: System Configuration
Setting Parameters On or Off
1. At the Setup screen, select
At the Parameters On/Off screen, selected parameters have a check mark.
2. Select the parameters to turn them on or off.
Use the arrows at the bottom of the screen to scroll through the list of
parameters.
3. Select
Setting up Parameter Units
Use this screen to select the units of measure for parameters:
1. At the Setup screen, select
The screen shows parameters for which you can select alternate units of
measure.
2. Select the parameter you want to change.
3. Select the units that you want to use for that parameter.
4. Select
5. Repeat Steps 2 through 4 to select the units for other parameters.
6. Select
NOTE:
saved earlier, the data may display differently on the reports. To see which
parameters have alternate units of measure, refer to Default and Alternate
Units of Measure‚ page 8-16.
Setting up Demographic Units
Use this screen to select the units of measure for sample demographics that have
units, such as temperature and F
1. At the Setup screen, select
2. Select the demographic you want to change.
3. Select the units that you want to use for that demographic.
4. Select
5. Repeat steps 2 through 4 to select the units for other demographics.
6. Select
Parameters > Parameter On/Off
.
Save
Parameters > Parameter Units
.
Save
.
Save
If you change units of measure and then print results for samples
O
I
Parameters > Demographic Units
.
Save
.
Save
.
2
8-15
.
.
.
02087462 Rev. V
Advertisement
Table of Contents
Troubleshooting
