Siemens Rapidlab 1200 Operator's Manual page 107

Rapidlab 1200 Operator's Guide: Operating the System
7. If prompted, enter demographic information and select
You can scan the patient ID and accession number in the appropriate field. For
more information about entering the data, refer to Entering Patient Sample
Data‚ page 2-22.
8. View the results.
For information about how results are displayed on the screen and in printed
reports, refer to Viewing Patient Results‚ page 2-27.
9. Select
CAUTION:
completely clean the fluid path, you must perform an additional wash. To
determine if the path is clean, observe if any colored fluid remains in the fluid
path after analysis. To perform a wash at the Analysis screen, select Wash.
The Wash button is grayed out if the system is busy. The Wash button is not
available if the lamp failure or LIS communications error indicators, which
occupy the same space on the screen, are active.
when you finish viewing the results.
Continue
If the wash that is performed after sample analysis does not
2-19
.
Continue
02087462 Rev. V