Siemens Rapidlab 1200 Operator's Manual page 337

Rapidlab 1200 Operator's Guide: System Configuration
1. At the Setup screen, select
2. Install the software:
NOTE:
installing the new software.
If you are
installing from...
CD-ROM,
Disks,
Network
connection,
The system shuts down and restarts to install the new software, moving the
database, as necessary. The system shuts down again and restarts using the
newly installed version of the software.
Depending on the size of your database, this installation can take some time.
A message displays indicating the installation was successful. The system
restarts, which takes several minutes.
3. Store the disks or CDs in a safe place, away from heat and strong magnetic
sources such as centrifuges.
Secured Options > Software Installation
Select at any time to exit from the installation without
Return
Then...
a. Select
CD-ROM
b. When prompted, install the CD.
c. Wait a few seconds until the system reads the data on the
CD.
d. Select
Continue
The system displays the current version number and the new
version number of the software.
e. Select
Continue
f. When prompted, remove the CD from the drive and select
.
Continue
a. Select
Disk
b. When prompted, insert the first disk into the disk drive and
select
Continue
The system displays the current version number and the new
version number of the software.
c. Select
Continue
d. When prompted, remove the disk from the drive, insert the
next disk in the sequence, and then select
e. Continue removing and inserting disks as prompted.
f. When prompted, remove the last disk from the drive and
select
Continue
a. Select
Network
Depending on the type of network configuration, enter either
the name or IP address of the computer that contains the new
system software.
Select
Save
The system displays the current version number and the new
version number of the software.
b. Select
Continue
.
.
to begin the installation.
.
.
to begin the installation.
.
.
.
to begin the installation.
8-43
.
.
Continue
02087462 Rev. V