Siemens Rapidlab 1200 Operator's Manual page 121

Rapidlab 1200 Operator's Guide: Operating the System
Report Name
Sample Totals
Last Cal Reports
Printer Report
Temperature/pAtm Report
Lamp Calibration Report
Wavelength Calibration Report
Sample Chamber Report
Voltages and Temperature Report
Leak Test Report
Measurement Test Report
Description
Prints a report of the total number of
patient and QC samples performed on the
system.
Refer to Viewing the Sample Totals‚
page 7-4.
Prints data for each sensor from the last
2-point or full calibration.
Refer to Using the Sensors Screen‚
page 6-44.
Prints all of the printable characters in the
printer memory.
Refer to Performing Tests and Printing
Diagnostic Reports‚ page 6-34.
Prints an index and one snapshot of the
heater readings.
Refer to Performing Tests and Printing
Diagnostic Reports‚ page 6-34.
Prints a Pass/Fail value for the CO-ox
lamp calibration. Only available on
Rapidlab 1245 and 1265 systems.
Refer to Performing the Lamp Calibration
Test‚ page 6-45.
Prints the result of the Wavelength
Calibration test. Only available on
Rapidlab 1245 or 1265 systems.
Performing the Wavelength Cal Test‚
page 6-46.
Prints a Pass/Fail value for the result of
the Sample Chamber test. Only available
on Rapidlab 1245 and 1265 systems.
Refer to Performing the CO-ox Sample
Chamber Test‚ page 6-46
Prints the historical Pass/Fail condition of
all voltages and temperatures.
Refer to Performing Tests and Printing
Diagnostic Reports‚ page 6-34.
Prints the result of the Leak Test.
Refer to Performing the Leak Test‚
page 6-37.
Prints measurement readings for all
sensors.
Refer to Performing Tests and Printing
Diagnostic Reports‚ page 6-34.
2-33
02087462 Rev. V