Entering Ip Addresses - Siemens Rapidlab 1200 Operator's Manual

Rapidlab 1200 Operator's Guide: System Configuration

Entering IP Addresses

Use this procedure to enter network IP addresses.
1. Obtain the following network information from your institution's network
administrator:
•
•
•
•
2. Select the communication settings at the Rapidlab 1200 system:
a. At the Setup screen, select
b. Select
c. Select
d. Select
e. Enter the IP addresses for the Rapidlab 1200 system, the default router
f.
3. At the Communications screen, select
4. When prompted that the connection was unsuccessful, select
5. Connect the network cable to the RJ-45 connector on the back panel of the
Rapidlab 1200 system.
6. Connect the network cable to the site network connection.
7. At the Rapidlink or Rapidcomm workstation, enter the communication
settings.
Refer to the Rapidlink Supervisor's Manual or Rapidcomm User's Guide.
8. At the Rapidlab 1200 system, select
9. Select
10. To complete any additional setup that may be necessary to operate the
Rapidlab 1200 system with the Rapidlink or Rapidcomm program, refer to the
Rapidlink Supervisor's Manual or Rapidcomm User's Guide.
IP address for the Rapidlab 1200 system
IP address for the Rapidlink or Rapidcomm server or workstation where
you want to connect the Rapidlab 1200 system
IP address for the default router port assigned to the network segment on
which the Rapidlab 1200 system is located
Network mask for the institution's network
CompleNet > Configure
.
Save
Enter IP Address
port, and the network mask.
Ensure that you enter the IP addresses and the network mask in the correct
fields.
Select .
Save
when finished.
Return
Printer and Devices > Communications
.
.
.
Save
.
Save
8-29
.
.
Continue
02087462 Rev. V