Table of Contents
Advertisement
5-44
5. Open the back cover.
1
2
3
Figure 5-21
6. Remove the lamp:
a. Stand directly behind the system and grasp the base of the lamp.
b. Pull the lamp out straight toward you.
c. Grasp the electrical connector and pull it straight back to disconnect it.
7. Dispose of the lamp according to your institution's protocol.
CAUTION:
glass may cause the lamp to prematurely deteriorate.
8. Install a new lamp:
a. Push the new lamp into the lamp receptacle area.
b. Push the electrical connector onto the electrical fitting.
9. Close the back cover.
02087462 Rev. V
Electrical connector
Lamp base
Back cover
Rapidlab 1200 System–back view
Pull steadily with increasing force until it comes free.
Avoid touching the new CO-ox lamp with your fingers. Touching the
The lamp has a key that you must line up with the key hole in the side of the
receptacle area.
Rapidlab 1200 Operator's Guide: Maintenance
Advertisement
Table of Contents
Troubleshooting
