Siemens Rapidlab 1200 Operator's Manual page 103

Rapidlab 1200 Operator's Guide: Operating the System
For an illustration of the sample port, refer to Figure 2-3 Rapidlab 1200
Systems Sample Port.
6. When prompted, remove the sample device and select
7. To start the sample moving through the sample path, select
CAUTION:
a short distance through the sample path to position 1. If you do not select an
option for the next stage of the procedure within 30 seconds, the system starts a
wash sequence and the sample becomes unusable.
8. Watch the sample move into the sample path and when the sample reaches
position 1, select
1
Figure 2-4
9. Select
Wait while the system analyzes pCO
analysis, it moves the sample to the remaining sensors.
Do not hesitate at any point during this procedure. The sample moves
Stop Sample
Sample position 1
Sample Position 1
.
Analyze
.
and pO . After the system finishes the
2 2
2-15
.
Continue
.
Advance Sample
02087462 Rev. V