Table of Contents
Advertisement
Figure 74. Removing and installing the blade filler panel
1 - Latch pull tab
2 - Latch release
Installing a filler panel
About this task
Complete the following steps to install a filler panel into a blade slot.
Procedure
1. Pull out the spring-loaded latch release on the latch at each end of the cover using your thumb and
forefinger and slide the latches toward the center of the cover.
2. Orient the filler panel over the empty slot and slide into the slot.
180
SAN256B-6 Installation, Service, and User Guide
Advertisement
Table of Contents
