Reinstalling The Febs; Figure 35: Reinstalling A Cb After Installing The M120 Router - Juniper Networks Hardware Manual

M120 Multiservice Edge Router Hardware Guide

Reinstalling the FEBs

72
All manuals and user guides at all-guides.com

Figure 35: Reinstalling a CB After Installing the M120 Router

To reinstall the FEBs (see Figure 36 on page 73):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Place one hand underneath the FEB to support it. With the other hand, hold one of
2.
the ejector handles on the FEB faceplate.
Carefully align the sides of the FEB with the guides inside the chassis.
3.
Carefully slide the FEB into the chassis, ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the FEB.
5.
Tighten the captive screws on the ejector handles.
6.
Repeat the procedure for each of the remaining FEBs.
7.
Copyright © 2010, Juniper Networks, Inc.