Figure 108: Installing a Lower Rear Fan Tray
Reinstalling the SCBs After Installing the MX960 Router with a Lift
To reinstall an SCB (see
CAUTION:
stored horizontally and pressed toward the center of the SCB.
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Carefully align the sides of the SCB with the guides inside the chassis.
3. Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
Figure 109 on page
327):
Before removing or replacing an SCB, ensure that the ejector handles are
326