Configuring With The Command Line Interface - Avaya 4524GT Configuration Manual

System configuration using ACLI

Configuring with the command line interface

This section covers ACLI commands needed to configure BootP parameters:
• ip bootp server command
• no ip bootp server command
• default ip bootp server command
ip bootp server command
The ip bootp server command configures BootP on the current instance of the switch or
server. Use this command to change the value of BootP from the default value, which is BootP-
when-needed.
The syntax for the ip bootp server command is:
ip bootp server {always | disable | last | needed}
Run the ip bootp server command in Global Configuration command mode.
The following table describes the parameters for the ip bootp server command.
Table 36: ip bootp server parameters
Parameters and
variables
always | disable | last I
needed
no ip bootp server command
The no ip bootp server command disables the BootP/DHCP server.
The syntax for the no ip bootp server command is
no ip bootp server
102 Configuration — System
on page 102
on page 102
on page 103
Specify when to use BootP:
• always: Always use BootP.
• disable: Never use BootP.
• last: Use BootP or the last known address.
• needed: Use BootP only when needed.
Important:
The default value is to use BootP when needed.
Description
April 2011