Configuring The Fabricfastethernet Interface - Avaya X330W-2USP Quick Start Manual

Wan access router module

Table of Contents

Configuring the FabricFastEthernet Interface

To configure a FabricFastEthernet interface:

Use the interface

FabricFastEthernet interface context, where the if-number format is

interface index]]

You do not need to include the ip-interface index if you configure only one IP interface.

Use the

ip address

For example: To configure the IP addresses 10.10.10.1 on VLAN 2 and 20.20.20.1 and

30.30.30.1 on VLAN 3 perform the following:

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address 10.10.10.1 24

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.1

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# ip address 20.20.20.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.2

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# ip address 30.30.30.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# exit

FabricFastEthernet <if-number>

command to assign an IP address to the interface.

command to enter the

port[:vlan[.ip-

Table of Contents