Configuring PoE port power detection control
Configure the PoE port power detection control to prevent power loss on the Ethernet Routing
Switch 8300.
Prerequisites
You must log on to the Interface Configuration mode in the ACLI.
Procedure steps
Configure the PoE port power detection control by using the following command:
poe detect-control port<portlist>
Variable definitions
Use the data in the following table to help you use the poe detect-control
port<portlist> command.
Variable
<auto|test>
Configuring PoE port type
Configure the PoE port type to manage the port assignment by application.
Prerequisites
You must log on to the Interface configuration mode in the ACLI.
Procedure steps
Configure the PoE port type by using the following command:
Configuration — Power over Ethernet
Set the port power detection control to auto or test.
Configuring PoE port power detection control
Value
May 2011
57