Saving the configuration
After you change the configuration, you must save the changes. Save the configuration to a file to
retain the configuration settings.
Note:
File Transfer Protocol (FTP) and TFTP support both IPv4 and IPv6 addresses, with no
difference in functionality or configuration.
Before you begin
Enable the Trivial File Transfer Protocol (TFTP) on the switch.
About this task
Use this procedure to save the configuration.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
save config
Configuring system identification
About this task
You can configure system identification to specify the system name, contact person, and location of
the switch, and to add a trap receiver to the trap-receiver table.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enable the Simple Network Management Protocol (SNMP) server:
snmp-server enable
3. Configure the read-only community name:
snmp-server community ro
Note:
Enter the community string twice.
September 2016
Quick Start Configuration
Comments on this document? infodev@avaya.com
Saving the configuration
37