Installation And Removal Of Network Module - Mitsubishi Electric MR-J4-TM Instruction Manual

Servo amplifier melservo-j4

Hide thumbs Also See for MR-J4-TM:

Table of Contents

1. FUNCTIONS AND CONFIGURATION

1.7.3 Installation and removal of network module

Before installing or removing network module, turn off the power and wait for 15

minutes or more until the charge lamp turns off. Then, confirm that the voltage

between P+ and N- is safe with a voltage tester and others. Otherwise, an electric

shock may occur. In addition, when confirming whether the charge lamp is off or

not, always confirm it from the front of the servo amplifier.

Avoid installing and removing the network module repeatedly. Any contact failure

of the connector may be caused.

The internal circuits of the servo amplifier and the network module may be

damaged by static electricity. Always take the following precautions.

Ground human body and work bench.

Do not touch the conductive areas, such as connector pins and electrical

parts, directly by hand.