Table of Contents
Advertisement
5. PARAMETERS
No./
Setting
symbol/name
digit
PA15
Set the encoder output pulses from the servo amplifier by using the number of
output pulses per revolution, dividing ratio, or electronic gear ratio. (after
*ENR
multiplication by 4)
Encoder
Selecting "Dividing ratio setting (_ _ 1 _)" of "Encoder output pulse setting selection"
output pulses
in [Pr. PC03] will divide the travel distance [pulse] of the linear encoder by the setting
value.
Set a numerator of the electronic gear for the A/B-phase pulse output when selecting
"A-phase/B-phase pulse electronic gear setting (_ _ 3 _)" of "Encoder output pulse
setting selection" in [Pr. PC03].
The maximum output frequency is 4.6 Mpulses/s. Set the parameter within this
range.
Setting range: 1 to 4194304
PA16
Set a denominator of the electronic gear for the A/B-phase pulse output.
*ENR2
Set a denominator of the electronic gear when selecting "A-phase/B-phase pulse
electronic gear setting (_ _ 3 _)" of "Encoder output pulse setting selection" in [Pr.
Encoder
PC03].
output pulses 2
Selecting "Dividing ratio setting (_ _ 1 _)" of "Encoder output pulse setting selection"
in [Pr. PC03] will disable the setting value.
Setting range: 1 to 4194304
Function
5 - 24
Initial
Network
value
ECT EIP
[unit]
4000
[pulse/
rev]
1
Advertisement
Table of Contents
