Table of Contents
Advertisement
16. FULLY CLOSED LOOP SYSTEM
16.2 Load-side encoder
16.2.1 Linear encoder
Refer to "Linear Encoder Instruction Manual" for usable linear encoders.
16.2.2 Rotary encoder
When a rotary encoder is used for the load-side encoder, use HG-KR or HG-MR servo motor as an encoder.
16.2.3 Configuration diagram of encoder cable
Configuration diagram for servo amplifier and load-side encoder is shown below. Cables used vary,
depending on the load-side encoder.
(1) Linear encoder
Refer to "Linear Encoder Instruction Manual" for encoder cables for linear encoder.
Servo amplifier
CN2
CN2L
(2) Rotary encoder
Refer to "Servo Motor Instruction Manual (Vol.3)" for encoder cables for rotary encoder.
Servo amplifier
CN2
CN2L
POINT
Always use the load-side encoder cable introduced in this section. Using other
products may cause a malfunction.
For details of the load-side encoder specifications, performance and assurance,
contact each encoder manufacturer.
Encoder of rotary servo motor
Encoder cable
(Refer to the "Linear Encoder Instruction Manual".)
Encoder of rotary servo motor
(Refer to the "Servo Motor Instruction Manual (Vol.3)".)
Encoder cable
16 - 4
Linear encoder
Load-side
encoder
Servo motor
HG-KR
Load-side
HG-MR
encoder
Advertisement
Table of Contents
