Mitsubishi Electric MR-J4-TM Instruction Manual page 183

5. PARAMETERS
No./ Setting
symbol/name digit
PC10 _ _ x x Analog monitor 2 output selection
MOD2 Select a signal to output to MO2 (Analog monitor 2). Refer to app. 8 (3) for detection
point of output selection.
Analog
monitor 2 Refer to [Pr. PC09] for settings.
output
_ x _ _ For manufacturer setting
x _ _ _
PC11 Set the offset voltage of MO1 (Analog monitor 1).
MO1
Analog
monitor 1
offset
Setting range: -999 to 999
PC12 Set the offset voltage of MO2 (Analog monitor 2).
MO2
Analog
monitor 2
offset
Setting range: -999 to 999
PC17 _ _ _ x For manufacturer setting
**COP4
_ _ x _ Linear scale multipoint Z-phase input function selection
Function
When two or more reference marks exist during the full stroke of the linear encoder,
selection C-4
set "1".
0: Disabled
1: Enabled
_ x _ _ For manufacturer setting
x _ _ _
PC18 _ _ _ x For manufacturer setting
*COP5
_ _ x _
Function
_ x _ _
selection C-5
x _ _ _ [AL. E9 Main circuit off warning] selection
Select an occurring condition of [AL. E9 Main circuit off warning].
0: Detection with ready-on and servo-on command
1: Detection with servo-on command
PC19 _ _ _ x [AL. 99 Stroke limit warning] selection
*COP6 Enable or disable [AL. 99 Stroke limit warning].
Function 0: Enabled
selection C-6
1: Disabled
When "Disabled" is selected, [AL. 99 Stroke limit warning] will not occur while LSP
(Forward rotation stroke end) or LSN (Reverse rotation stroke end) is off, but the
operation will be stopped with the stroke limit.
_ _ x _ For manufacturer setting
_ x _ _
x _ _ _
Function
5 - 44
Initial
Network
value
ECT EIP
[unit]
01h
0h
0h
0
[mV]
0
[mV]
0h
0h
0h
0h
0h
1h
0h
0h
0h
0h
0h
0h