Mitsubishi Electric MR-J4-TM Instruction Manual page 101

Servo amplifier melservo-j4

Hide thumbs Also See for MR-J4-TM:

Table of Contents

3. SIGNALS AND WIRING

You can also use a ferrule to connect with the connectors. When using a ferrule, select a ferrule and

crimping tool listed in the table below.

Servo amplifier

MR-J4-10TM to

MR-J4-200TM to

MR-J4-60TM4 to

MR-J4-350TM4

MR-J4-10TM1 to

(b) Inserting wire

Insert the open tool as follows and push down it to open the spring. While the open tool is pushed

down, insert the stripped wire into the wire insertion hole. Check the insertion depth so that the cable

insulator does not get caught by the spring.

Release the open tool to fix the wire. Pull the wire lightly to confirm that the wire is surely connected.

The following shows a connection example of the CNP3 connector for MR-J4-200TM and MR-J4-

Ferrule model (Phoenix Contact)

AI-TWIN2×1.5-10BK

AI-TWIN2×2.5-10BU

AI-TWIN2×1.5-10BK

1) Push down the open tool.

3) Release the open tool to fix the wire.

2) Insert the wire.

Crimping tool

(Phoenix Contact)

CRIMPFOX-ZA3