Ipv6 Nd Other-Config-Flag - Cisco Sx350 Cli Manual

28
569
Parameters
•
milliseconds
—Interval between IPv6 neighbor solicit transmissions. The
acceptable range is from 1000 to 3600000 milliseconds.
Default Configuration
0 seconds (unspecified) is advertised in router advertisements and the value 1000
milliseconds is used for the neighbor discovery activity of the router itself.
Command Mode
Interface Configuration mode
User Guidelines
This value will be included in all IPv6 router advertisements sent out this interface.
Very short intervals are not recommended in normal IPv6 operation. When a
non-default value is configured, the configured time is both advertised and used
by the router itself.
Example
The following example configures an IPv6 neighbor solicit transmission interval of
9000 milliseconds for VLAN 1:
switchxxxxxx(config)#
switchxxxxxx(config-if)# ipv6 nd ns-interval 9000
switchxxxxxx(config-if)#

28.17 ipv6 nd other-config-flag

Use the ipv6 nd other-config-flag command in Interface Configuration mode to set
the Other Stateful configuration flag in IPv6 router advertisements.
To clear the flag from IPv6 router advertisements, use the no form of this
command.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
interface vlan 1
exit
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Commands