Bridge Multicast Ip-Address - Cisco Sx350 Cli Manual

4
129
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered, using
bridge multicast address.
You can execute the command before the VLAN is created.
Example
The following example forbids MAC address 0100.5e02.0203 on port gi14 within
VLAN 8.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
add gi14
4.5

bridge multicast ip-address

To register IP-layer Multicast addresses to the bridge table, and statically add or
remove ports to or from the group, use the bridge multicast ip-address IInterface
(VLAN) Configuration mode command. To unregister the IP address, use the no
form of this command.
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
interface vlan 8
bridge multicast address 0100.5e02.0203
bridge multicast forbidden address 0100.5e02.0203
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands