Dot1X Guest-Vlan Enable - Cisco Sx350 Cli Manual

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example defines VLAN 2 as a guest VLAN.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
3.8

dot1x guest-vlan enable

To enable unauthorized users on the access interface to the guest VLAN, use the
dot1x guest-vlan enable command in Interface Configuration mode. To disable
access, use the no form of this command.
Syntax
dot1x guest-vlan enable
no dot1x guest-vlan enable
Parameters
N/A
Default Configuration
The default configuration is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The port cannot belong to the guest VLAN.
The guest VLAN and the WEB-Based authentication cannot be configured on a
port at the same time.
This command cannot be configured if the monitoring VLAN is enabled on the
interface.
If the port does not belong to the guest VLAN
VLAN as an egress untagged port.
interface vlan 2
dot1x guest-vlan
itThe port is added to the guest
3
88