Next-Server-Name - Cisco Sx350 Cli Manual

12
305
Example
The following example specifies 10.12.1.99 as the IP address of the next server:
switchxxxxxx(config-dhcp)#

12.18 next-server-name

To configure the next server name (sname) in the boot process of a DHCP client,
use the next-server-name command in DHCP Pool Network Configuration mode or
in DHCP Pool Host Configuration mode. To remove the boot server name, use the
no form of this command.
Syntax
name
next-server-name
no next-server-name
Parameters
•
name
—Specifies the name of the next server in the boot process. (Length:
1–64 characters).
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No next server name is defined.
User Guidelines
The client will connect, using the SCP/TFTP protocol, to this server in order to
download the configuration file.
Example
The following example specifies www.bootserver.com as the name of the next
server in the boot process of a DHCP client.
next-server 10.12.1.99
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
DHCP Server Commands