Table of Contents
Advertisement
47
929
This command is only available when QoS is in advanced mode.
Example
The following example creates an ACL, places it into a class map, places the class
map into a policy map and redirects the flow to Ethernet port gi12:
switchxxxxxx(config)# ip access-list extended ip1
switchxxxxxx(config-ip-al)# permit ip any any
switchxxxxxx(config-ip-al)# exit
switchxxxxxx(config)# class-map c1
switchxxxxxx(config-cmap)# match access-group ip1
switchxxxxxx(config-cmap)# exit
switchxxxxxx(config)# policy-map p1
switchxxxxxx(config-pmap)# class c1
switchxxxxxx(config-pmap-c)# redirect gi12
switchxxxxxx(config-pmap-c)# exit
switchxxxxxx(config-pmap)# exit
switchxxxxxx(config)#
47.13 mirror
Use the mirror Policy-map Class Configuration mode. command to mirror a traffic
flow to an analyzer Ethernet port.
Syntax
session_number
mirror
no mirror
Parameters
•
session_number
RSPAN session. Only a value of 1 is allowed.
—Specify the session number identified with the SPAN or
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Quality of Service (QoS) Commands
Advertisement
Table of Contents
